SpeedBox 3.0 for Giant (without RideControl Go)

SpeedBox 3.0 for Giant (without RideControl Go)

This third-generation tuning chip not only lifts the 25 km/h speed limit of your Giant e-bike, you can even set the desired maximum speed to an individual value. This can be done conveniently via the control buttons of your e-bike; you don't need a PC or display.

Even with active tuning, your e-bike display shows all values correctly (speed, distance, range, etc.).

Simple operation

After installation, the tuning can be conveniently switched on using the control buttons of the e-bike. Briefly press the WALK button and the display briefly shows a value of 9.9 km/h - this signals that the tuning has been activated and the speed limit has been lifted.

The tuning can be deactivated at any time by pressing the WALK button again - the display then briefly shows a value of 2.5 to confirm this - this signals that the tuning has been cancelled and the speed has been limited to 25 km/h again. Your e-bike will then function normally again, as if no tuning chip had been installed.

Tip: For e-bikes without a WALK button, the tuning can alternatively be activated / deactivated with the key combination + - + -.

Setting the maximum speed

To set the maximum supported speed, first switch the mode three levels down and then three levels up. After that, the current speed limit is displayed.

You can change the level of the maximum supported speed by briefly pressing the WALK button or by turning the rear wheel 360°. A displayed speed of 1.5 km/h would then correspond to a maximum speed of 15 km/h, a 2.0 km/h display would correspond to a maximum speed of 20 km/h, 3.0 km/h would correspond to 30 km/h, and so on.

After 5 seconds of inactivity, the last speed limit displayed is saved.

Installation

The SpeedBox 3.0 is a chip or module that must be connected directly to the motor. To simplify the installation, coloured plugs with a key are used for the correct connection.

-First you have to switch off your e-bike and remove the battery.

-Then you must remove all the necessary parts of the e-bike to gain access to the connectors at the motor.

-Disconnect the connectors on the cable from the motor to the speed sensor and from the motor to the display.

-Connect the SpeedBox to the disconnected connectors.

-Reassemble the e-bike to its original condition.

-Switch on the e-bike and activate the tuning by pressing the WALK button.

-That's it - your GIANT E-bike is now tuned and you can ride much faster with full motor support!

If at some point you want to restore your e-bike to its original condition, you can remove the tuning chip again at any time.

Important note: If you want to install the SpeedBox in a brand new GIANT e-bike, you must first ride the bike for at least 1 km before switching on the chip for the first time.

The SpeedBox does not need its own battery.

SpeedBox 3.0 for Giant - Compatibility

This tuning tool is compatible with Giant Yamaha SyncDrive e-bikes model year 2017-2023 without RideControl Go.

NOT compatible with software updates from 2022 onwards.

Not compatible with SyncDrive Pro motor with RideControl Go.

Not compatible with Giant Talon, Explore, Fathom (produced 2022-2023).

Not compatible with SpeedBox app.

Important: The manufacturer recommends NOT to carry out any updates on the e-bike.

Note: This tuning tool is also available in a "B.Tuning" version that is compatible with the SpeedBox app. This allows you to benefit from various additional functions, e.g. driving data analysis, engine lock, hide tuning, etc.