MTT SmartSP for Bosch Smart System 2022

Mountain Tuning Module Plugin for Bosch Smart System (BES3) / Plugin

This MTT SmartSP is a practical tuning module for removing the 25 km/h speed limit of e-bikes with Bosch Smart System drive. Unlike the MTT Sensor ("MTT SmartSB"), the MTT SmartSP is a convenient plug-in solution that is very compact and particularly easy to install. The module is tiny and, unlike some other modules, fits into even the smallest engine compartment. Once connected, the MTT Plugin enables riding with full motor support, even at speeds significantly above 25 km/h.

The MTT does not need its own battery; power is supplied via the bike. When tuning is activated, the display will no longer show any real values above a speed of 25 km/h. Tip: We recommend the use of GPS-enabled additional devices such as your smartphone if you want to have the correct speed displayed on the road. Suitable mounts for the handlebars are available in our shop.

This tuning tool is made in Germany.

Three different operating modes

You can switch MTT Tuning on and off as desired. There are three different operating modes to choose from. The required operating mode is set when the e-bike is started up by certain wheel movements that move the spoke magnet along the sensor.

-Tuning permanently activated (factory setting): Speed limit is cancelled, the real speed is only displayed up to 25 km/h.

-Tuning permanently deactivated: The e-bike functions as in it's original state (motor support up to 25 km/h, correct speed display).

-Tuning according to switch-on condition: Here you can decide spontaneously when switching on the bike whether the tuning plug-in should be activated or not. To activate the tuning, the magnet must be at least 4 seconds in front of the sensor when the bike is started up. If this is not the case, the tuning remains deactivated.

You even have the possibility to individually adjust the maximum supported speed by means of certain wheel movements. 

Note: When delivered, the MTT is always in the mode "Tuning permanently activated", with the highest supported speed limit.

Functionality

After installation, the MTT (when tuning is active) will analyse and process the current speed profile and pass on manipulated values. This outsmarts and eliminates the preset 25 km/h speed limit, so that you can ride much faster with full motor support.

Please note:

Since the MTT plugin locks off speeds above 25 km/h for the engine firmware when tuning is active, the displayed speed always remains ≤ 25 km/h. This means that only up to 25 km/h the real speed is displayed.

Therefore, the total kilometre display of the system will also no longer correspond to the real distance travelled.

Installation

For installation, the MTT Tuning Plugin must be installed in the engine compartment.

To gain access to the plug-in connections, the plastic cover of the engine (and sometimes also a crank) must be removed briefly.

MTT for Bosch Smart System - Compatibility

This tuning module is compatible with e-bikes with the "Bosch Smart System" drive system, sometimes referred to as "Bosch Gen4 2022", "Bosch Gen5" or "BES3" ("Bosch Development Stage 3"). This drive system uses mid-mounted motors.

Not compatible with Bosch Smart System e-bikes with ABS system!

Important: Not compatible with e-bikes that have a magnet on the valve. These sensors are installed deep in the motor and cannot be optimised by modules.