SpeedBox 3.1 for Giant (RideControl Go)

SpeedBox 3.1 for Giant (RideControl Go)

Important: The manufacturer recommends NOT to perform software updates on the e-bike!

This is a reliable third generation tuning chip that completely removes the 25 km/h speed limit of e-bikes with Giant SyncDrive Pro Motor 2022 and RideControl Go. You even have the option of setting the maximum top speed to an individual value.

Even with active tuning, the e-bike display shows correct values such as speed, daily distance and range.

Tuning can be switched on and off

After installing the SpeedBox 3.1 chip, the tuning can be easily switched on with the WALK button. The display briefly shows a value of 9.9 km/h - this signals that the tuning has been activated and the speed limit has been lifted.

To switch off the tuning, simply press the WALK button again - a short 2.5 km/h display then signals that the tuning has been cancelled and the maximum supported speed is limited to 25 km/h again. After this, your e-bike will function as it did before the chip was installed.

Tip: For e-bikes without a classic control panel with WALK button, the tuning can alternatively be switched on and off with the key combination + - + -.

Setting the maximum speed

The desired maximum speed can also be conveniently set using the control buttons of the e-bike, entirely without a PC or smartphone.

First switch the mode three levels down and then three levels up. Then the current speed limit is displayed. To change the maximum speed, briefly press the WALK button or turn the rear wheel 360°.

A displayed speed of 1.5 km/h would correspond to a maximum speed of 15 km/h, a 2.0 km/h display would correspond to 20 km/h, 3.0 km/h would correspond to 30 km/h, and so on.

After 5 seconds of inactivity, the last displayed speed limit is saved.

Installation

The SpeedBox 3.0 is a module or chip that must be connected to the engine. Thanks to colour-coded connectors, installation is simple and can also be done by yourself.

-First you have to switch off your e-bike and remove the battery.

-Then remove all parts of the e-bike so that you have access to the connectors on the motor.

-Disconnect the connectors on the cable from the motor to the speed sensor and from the motor to the display.

-Connect the SpeedBox to the disconnected connectors.

-Return the e-bike to its original condition.

-Switch on the e-bike and activate the tuning by pressing the WALK button.

That's it - your GIANT E-bike is tuned now and you can ride much faster with full motor support!

If at some point you want to restore your Giant e-bike to its original condition, you can easily remove the tuning chip at any time.

Important note: If you want to install the SpeedBox in a brand new GIANT e-bike, you must first ride the bike for at least 1 km before switching on the chip for the first time.

The SpeedBox does not require its own battery.

SpeedBox 3.1 for Giant (RideControl Go) - Compatibility

-RideControl Go

-Giant SyncDrive Pro motor from model year 2022.

NOT compatible with engines and software updates from 2023 onwards.

Not compatible with the SpeedBox App.

Not compatible with Giant Revolt E+ (2022-2023) / EnergyPak Plus.

Important: The manufacturer recommends NOT to perform software updates on the e-bike!

Note: This tuning tool is also available in a "B.Tuning" version that is compatible with the SpeedBox app. This allows you to benefit from various additional functions, e.g. ride data analysis & engine lock, hide tuning etc....